速凍式氣體干熱機
◆護膚品性能 Product features
空調制冷及氣體程序,經專家教授確切來計算,的設計指標均留20%大于的容量。縮短機擠壓機擠壓機用到高速回轉式或渦旋縮短機式、活塞式式全全封閉式式縮短機擠壓機擠壓機及半全封閉式式螺母式縮短機擠壓機擠壓機(20HP之內),運營維持,的噪音低,能靠譜,低耗電期長。功效比好,隔離技能等級為IP54(防火及防濺)
熱調換器、風蒸發器器選則好的無縫鋼管帶純鋁鰭片,攏流節構特征換熱器勞動生產率好、以至于體型大小小,節構特征緊促。壓力容器封頭用料選則不銹鋼材質或碳鋼板熱浸鍍鋅,可減少對收縮氣流的2次被污染的。冷暖空調的控制組件特性良好的。擁有供熱公司澎漲閥的節流降血壓實用效果,熱流旁通閥的勢能調低實用效果,過電壓電流、過阻抗、氟利昂高壓力確保等實用效果。
液氣溶合器按照漩風溶合與不銹剛絲網捕霧充分聯系,具備著液氣溶合目的完全徹底,預防水分含量的第二次蒸餾,確定冷干機的吹干目的。它比漩風溶合器性好,還又比過濾水式液氣溶合器安全操作成體低,具備著性價位比。水空調蒸發器器為高質低翅熱管,慢水流量、多沖程,板換成功率好,長期性安全操作不容易積灰。重新排水障礙器按需使用,除水加低碳,目的好;浮球式,手機定時任務自選擇。外電機轉子冷電扇,大風天氣量、低噪音分貝,過多停止長蓄電量。
承受壓力部分專用設備結構類型來設計恰當,易于運維大保養;表面上熱噴塑,形壯精美,不銹蝕;無依據組裝,加載保持穩定無震動,返修率低,無總量品,加載的費用少,反復加載不需要人員等候。
Refrigeration and air system, the experts accurate calculation, design parameters are left more than 20% of the surplus. Refrigeration compressors adopt international advanced rotary or scroll type, piston enclosed refrigeration compressor and close partly screw refrigeration compressor (20 HP above), stable operation, low noise, reliable performance, save electricity long life. Can effect comparing high, protection grade for IP54 (dust and splash)
Heat exchanger, wind condenser copper pipe with high quality with pure aluminum fins on heat flow structure, high yield, and thus, small size, structure compact. The cylinder body materials selecting stainless steel or carbon steel galvanized, can avoid to compressed air of the secondary pollution. Refrigeration control elements adopt the most advanced Denmark danfoss (DANROSS) and the Persian LAN (SPORLAN), (ALCO) refrigeration components, excellent performance. Thermal expansion valve with the throttling step-down function, heat the by-pass energy adjustment function, over electric current, the load, cold media high voltage protection.
Liquid-vapor separator using whirlwind separation and stainless steel wire the organic combination of the trap with gas liquid separation effect of moisture, avoid completely secondary evaporation, ensure the blotting etc.is dry effect. It than cyclone separator performance is good, at the same time than a gas-liquid separator filter brand-newly type use adult, and has a low price is high performance. Water condenser copper pipe for high quality, low wing, stroke, slow flow in high thermal efficiency, use for a long time shoulds not be scaled. Automatic drainage device according to the needs, in addition to water and energy saving set, the effect is good; Float type, electronic timing can choose.The cold wind, big rotor fan air, low noise, long life. Stop frequent rev.
Parts are confined by national gb1501998 "steel pressure vessel" and GB151-1999 "tubular heat exchanger of manufacture, test and check and accept," pressure vessel safety technology supervision code "supervision. Equipment structure design is reasonable, facilitate maintenance; The surface heat spraying, beautiful appearance, not rust; No basis installation, smooth operation no vibration, maintenance rate is low, no consumables, operation cost less, without waiting for continuous operation special.
工作能力與技木指標體系 Working condition and technical indexes | |
進氣溫度表 The inlet temperature |
低溫型≤50℃,耐高溫型≤80℃ |
放置冷卻方法 Cooling way |
風冷(水冷散熱器) |
周圍環境平均溫度 Environment temperature |
≤40℃(風冷) |
壓露點 Pressure dew point |
1.7℃~10℃(0.7 MPa) |
冷暖空調劑 Refrigerants |
R-22或隨著客人想要可采用了R134a,R404 a,R507等無氟環保健康空調制冷機組。 |
進氣負壓 The inlet pressure |
0.2~1.0MPa(6.4 MPa下述接手備貨) |
負壓盤虧 The pressure loss |
≤0.02 MPa |
急冷水漏電濕度 Cooling water inlet water temperature |
≤32℃(散熱) |
冷凝水漏水壓差 Cooling water feed water pressure |
0.15~0.4 MPa(水冷散熱) |
◆核心技藝性能指標 Main technical parameters
ADH |
-5F |
-10F |
-20F |
-30F |
-60F |
-75F |
-120F |
-150F |
-200F |
-250F |
-300F |
-400F | |
進行排污量 Capacity m3/min |
0.7 |
1.6 |
2.6 |
3.8 |
7.0 |
8.5 |
13.5 |
17 |
23 |
27 |
34 |
45 | |
運行有壓力 Work pressure |
| ||||||||||||
露點溫暖 Dew point temperature |
| ||||||||||||
制泠劑 Refrigerants |
R-12 |
| |||||||||||
開關電源 Power |
|
| |||||||||||
減少機電機功率 Compressor power(KW) |
0.18 |
0.28 |
0.6 |
0.75 |
1.1 |
1.3 |
2.2 |
2.9 |
3.7 |
4.8 |
5.5 |
7.5 | |
空調風扇主軸電機輸出 Fan motor power(W) |
30 |
170 |
170 |
180 |
300 |
300 |
510 |
510 |
600 |
720 |
900 |
1200 | |
接口類型尺寸 Interface size |
ZG1/2" |
ZG1" |
ZG1" |
ZG1.5" |
ZG1.5" |
ZG2" |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL | |
形狀長寬 Appearance and size |
長L(mm) |
530 |
800 |
800 |
800 |
1100 |
1100 |
1550 |
1400 |
1550 |
1800 |
1900 |
2000 |
寬W(mm) |
360 |
450 |
450 |
450 |
600 |
600 |
650 |
780 |
780 |
780 |
950 |
950 | |
高H(mm) |
490 |
970 |
970 |
970 |
1250 |
1250 |
1480 |
1580 |
1580 |
1580 |
1800 |
1800 | |
凈含量 Weight(kg) |
50 |
95 |
100 |
100 |
210 |
250 |
350 |
470 |
550 |
650 |
800 |
1000 |